Era Replica Automobiles 427 ROADSTER, Assembly And Service Manual

Page: 127 / 165

SECTION G - BODY/INTERIOR
127
SHOULDER HARNESSES
Locate the mounting holes in the chassis with an awl, and
cut holes in the carpet. See page 83. The optional four-
point shoulder harness are installed with the (
7
/
16
"-20)
attaching bolts above the belt loops.
LAP BELT LAYOUT
Note that the shoulder harness latching pieces angle down
into the lap belt hardware.
SEAT MOUNTING
Lay the floor carpets in place, and locate the seat mounting
holes through the carpet. Mark and cut holes for the bolts
in the carpet.
If you are not using seat adjusting rails, each seat must be
raised up approximately ½”with spacers.
WITH ADJUSTING TRACKS
The lever for the seat tracks falls on the right side of both
the driver's and passenger's seats.
The seats have captive nuts for the adjusting tracks in the
seat bottom. Install the adjustment tracks, if used, to the
seat base first with
1 /
4
-20 bolts. Make sure they don't stick
up through the base and prevent the cushion from seating.
Put 2 1 /
8
" shims (supplied with the seat tracks) under the
right front holes over the tunnel. Put 3
1
/
8
" shims under the
left front holes. Place the seats so that the studs in the
tracks go through the holes in the floor. Note that large
washers are used under the floor on three studs and a small
washer is used on the inside front.
If the seat does not slide freely, loosen all four bolts, slide
the seat back and forth to align the tracks and re-tighten.
WITHOUT ADJUSTING TRACKS
If seat adjusting tracks are not used, follow the previous
instructions, using the spacers and bolts provided to raise
the seat base.