Epson FILMSCAN 200, User Manual

Page: 117 / 151

The interface board is not
installed correctly. Make sure that the board is installed
correctly and securely.
For EPSON FilmScan 200
(parallel model) users:
The I/O port address of the
parallel interface board is
already taken by another
device. Change the I/O port address to an
unused value. See your computer and
parallel interface user’s guides. Write
down the I/O port address, as you
will need to specify it when making
the port settings in the EPSON Scanner
Setup dialog box.
For EPSON FilmScan 200
(parallel model) users:
The interface board is not
compatible with your scanner. Install the EPSON bidirectional
interface board that came with your
scanner. See the interface board’s
documentation for instructions.
For EPSON FilmScan 200
(parallel model) users:
The I/O port address of the
parallel interface board does
not match the port address in
EPSON TWAIN. Check the I/O port address of the
interface board, and change the I/O
port address setting in the EPSON
Scanner Setup dialog box to match the
address of the interface board. See
page 3-6 for information on port ID
settings.
Note:
Even if the EPSON parallel interface
board that came with your scanner is
installed, you will need to change the I/O
port address if you have changed its
jumper setting. Write down the I/O port
address, as you will need to specify it when
making the port setting in the EPSON
Scanner Setup dialog box.
For EPSON FilmScan 200
(SCSI model) users:
The computer was turned
on before the scanner.
Turn off the scanner and your computer.
Turn on the scanner; then turn on your
computer. See “Power-on sequence” in
Chapter 2.
L
Onion Ref. Guide
Rev.c
A5 size Chapter 7
02-07-97 DR, pass 1
7-10 Troubleshooting