Version 2.65 Jul. 2009
22
User's Manual
Installer, SetupPOS, TMUSB
be sure to perform a reinstallation.
At this point, all the information necessary for the version upgrade shall be
updated. It may take a few minutes for all the operations to be completed.
(13) When all the operations are completed, the “Setup Complete” dialog box is
displayed. Select in the check box whether or not to display the release
note on the installed EPSON OPOS ADK. It is strongly recommended to
read the notes.
(14) If system files are renewed because of the installation, rebooting of system
may be requested. In this case, please specify whether rebooting right
away or later, and execute the rebooting. If later rebooting is specified,
make sure to reboot after the completion of the installation. The operation
under the un-rebooted environment is not guaranteed at all.
(15) Installation is completed. The SetupPOS utility starts up. Confirm the
settings in accordance with the setup described in “Section 5. SetupPOS
Utility” of this manual. When system rebooting is executed, SetupPOS
utility does not start automatically. Please start SetupPOS utility from start
menu.
3.3.2. Overwriting Installation
With the installation of EPSON OPOS ADK in advance, install according to the
following procedure.
3.3.2.1. Overwriting Version 2.60 by Version 2.60
When performing an overwrite installation, user information, specified installation
destination, and specified program folder in the previous installation will remain
effective. This information cannot be changed. If a version of EPSON OPOS ADK
has been already installed, when you try to install the same version, Add-in
Installation starts. In this case, only the installed devices and files are overwritten.
This overwriting is not able to overwrite in Windows Vista environment.
<Installation Procedure>
(1) Run the SETUP.EXE program on disk 1.
Before running SETUP.EXE, close the other programs already running.
Otherwise, installation may fail. It takes some time for Setup to start. Wait
a while.
