Security
Biometra TOne
10
2.2
Requirements for the operating personnel
The device must only be operated by qualified specialist personnel instructed in the
use of the device. This instruction also include teaching the contents of this user
manual and of the user manuals of the connected system components. We recom-
mend training by qualified employees of Analytik Jena or its representatives.
In addition to the safety instructions in this user manual, the general applicable
safety and accident prevention regulations of the respective country the device is op-
erated in must be observed and adhered to. The operator must ensure the latest ver-
sion of these regulations.
The user manual must be accessible to the operating and service personnel.
2.3
Safety instructions for transport and commissioning
¡
Please verify that the delivery is complete upon receiving the device and check
for possible transport damage. Only start the device when it is free from defects.
Please address any complaints and claims to the manufacturer.
To prevent health damage, the following must be observed when moving the device
in the laboratory (lifting and carrying):
¡
The device has no carrying handles. To transport the device, grip the device
firmly at the bottom with both hands and lift it.
¡
Empty the sample block before transporting the device. There must be no sam-
ple vessels in the block.
¡
Only send the device in its original packaging and with transport locks in place.
¡
Risk of damage to health due to improper decontamination! Perform a profes-
sional and documented decontamination of the device before returning it to An-
alytik Jena. The decontamination report is available from Service when register-
ing the return. Without a completed decontamination report, the acceptance of
the device will be refused. The sender may be liable for damage caused by inade-
quate decontamination of the device.
2.4
Safety instructions: during operation
2.4.1
Summary of safety instructions
The operator must make sure that the device and its safety equipment is in sound
condition each time before starting up the device. This applies in particular after
each modification or extension of the device or its repair.
Observe the following:
¡
The device may only be operated if all items of protective equipment (e.g. covers
in front of electronic components) are in place, properly installed and fully oper-
ational.
¡
The sound condition of the protection and safety equipment must be checked
regularly. Any defects must be corrected as soon as they occur.
¡
Protective and safety equipment must never be removed, modified or switched
off during operation.
¡
Always ensure free access to the main switch and to the emergency shutdown
switches and locks during operation.
