ENCAD T-200, Service Manual

Page: 78 / 162

ENCAD T-200 and T-200+ Service Manual
Maintenance 3-38
Paper Axis Calibration
The paper axis calibration procedure ensures that the processing that
drives the stepper motor is correct to minimize line length accuracy
errors.
To perform the paper axis procedure:
Depress the “Menu” key on the control panel to begin the main
menu subroutine.
Using the “Up Arrow”, Down Arrow” and “Select” keys on the
control panel select:
Utility Menu
Paper Calib
Calib XY=(“On” or “Off”)
Ensure that Calib XY is set to ON and press “Select.” This
allows the printer to store the data that is entered in the
following steps.
Then select:
Paper Axis Test
This runs the paper axis test which prints out two “
T
” figures that
are mirrored from each other and about 33” apart. See Figure 3-27.