ENCAD T-200, Service Manual

Page: 128 / 162

ENCAD T-200 and T-200+ Service Manual
Assembly\Disassembly 5-26
TABS
Figure 5-17. Carriage Bushing Installation.
5. Orient the new Bushing as shown in Figure 5-17 so that the metal
tab on top of the Bushing goes into the Carriage Assembly first.
6. Push the Bushings in until they snap into place.
7. Perform the Reinstall the Carriage Assembly, Carriage Belt, and
the Frame Tensioner procedures to reinstall the Carriage Assembly
if Carriage was removed.
Reinstalling the Carriage Assembly, Carriage Belt
and the Frame Tensioner
1. To install the Belt onto the Carriage Assembly, the “bumps” on the
belt (where the ends of the belt are joined together to make the belt
continuous) must be positioned between the left and right posts of
the Belt Clamp. See Figure 5-12.
2. Slide the Carriage Belt between the right post and the middle post
and guide it down into the Belt Clamp. Then slide the Carriage Belt
between the left post and the middle post and finish placing the
Carriage Belt into the Belt Clamp.
3. Check the position of the Carriage Belt to make sure it matches
Figure 5-12.
4. Make sure the left end of the Trailing Cable extends out beyond the
left end of the Trailing Cable Support Assembly.