ENCAD T-200, Service Manual

Page: 140 / 162

ENCAD T-200 and T-200+ Service Manual
Assembly\Disassembly 5-38
6. Using a #1 6” or 8” Phillips screwdriver, remove the 4 black flat-
head screws which hold the left and middle Drive Shaft Supports in
place. There are two screws in the center of the Platen, and two
screws approximately three inches to the left of the left brass
bracket. See Figure 5-22.
7. Remove the left Drive Shaft Support through the left end of the
Platen and the middle Drive Shaft Support through the Snap Plug
opening.
NOTE
Be very careful when removing the Foam Block so that it
does not tear. If it does tear, however, it must be replaced
with a new one so that the Inner Platen has sufficient
vacuum.
8. Remove the Foam Block which is beside the Stepper Motor
Assembly by putting your index finger into the opening in the top of
the Foam Block and pulling it towards you. See Figure 5-23.
FRONT OF
PLATEN
FOAM
BLOCK
ALL CABLES PASS THROUGH THE
FOAM BLOCK THROUGH THIS CORNER
Figure 5-23. Removing the Foam Block.