ENCAD T-200, Service Manual

Page: 111 / 162

ENCAD T-200 and T-200+ Service Manual
Assembly\Disassembly 5-9
Memory Module Installation
The memory module is secured by locking tabs located at both of the
narrow edges of the module. To install the memory module, verify that
the locking tabs are in the unlocked position then align the module over
the slot, ensuring that the module is oriented properly. While applying
equal pressure to both edges of the module press the module down into
the slot until both tabs are locked into the module.
Reinstalling the Right Cover Assembly
1. Make sure that all wires are inside the Right Cover Assembly area
as you begin to put the Right Cover Assembly back on so that none
of the wires are pinched between the Right Cover Assembly and the
Right Side Plate.
2. Align the back of the Right Cover Assembly over the connector clips
on the parallel port. Remove the rubber band holding the connector
clips together.
3. Reinsert all three screws on the inside of the Right Cover Assembly.
See Figure 5-1. All three screws should be torqued to 15 in-lbs. Do
not overtighten.
4. Put the Top Cover back on.
Removing the Left Cover
Removing the Left Cover provides access to the Power Supply and the
Power Entry Module.
To remove the Left Cover, proceed as follows:
1. Remove the Top Cover. Keep the right end of the Top Cover tilted
up so that the Retracting Stop and Compression Spring don’t fall
out.
2. While holding the Left Cover, remove the three screws securing the
Left Cover. The three screws are removed from the the left side of
the cover as shown on Figure 5-4.