ENCAD T-200, Service Manual

Page: 137 / 162

ENCAD T-200 and T-200+ Service Manual
Assembly\Disassembly 5-35
in the Y-Arm and use the 7/64 Hex Nut Driver to tighten them.
(The exact positioning of the screws in the slot will be done later
during the Carriage Height Adjustment in Chapter 3.)
2. Reinstall the Carriage Assembly. (The Trailing Cable Cover will
be reattached later.)
3. Slide the Carriage Assembly back and forth a few times to make
sure it moves easily. Make certain that it travels easily all the
way to the left end of the Slide Shaft so that the Cutter activates.
4. Once you have checked the movement of the Carriage Assembly,
follow the procedures for attaching the Trailing Cable to the tapes
on the Stabilizer Bracket.
5. Reattach the Trailing Cable Cover.
6. Reattach the Left Cover.
7. Reinstall the Cartridges and the Top Cover.
8. Perform the Carriage Height Adjustment procedure located in
Chapter 3.
Disassembly of Plotter Before Removing the Inner
Platen Parts
Refer to previous sections of this chapter and Figure 5-21 as necessary
during this procedure. To obtain access to the Inner Platen Parts:
1. Remove the Top Cover and the Left Cover.
2. Remove the Right Cover Assembly.
3. Disconnect all the connectors from the MPWA.
4. Remove the MPWA.
5. Remove the Right Side Plate.
6. Remove the Display Assembly.