ENCAD T-200, Service Manual

Page: 104 / 162

ENCAD T-200 and T-200+ Service Manual
Assembly\Disassembly 5-2
Always turn the printer OFF, remove the power cord
and the interface cable before beginning any disassem-
bly procedures. An electrical shock hazard may be present
if these precautions are not followed.
Removing the Right Cover Assembly
Removing the Right Cover Assembly provides access to the Memory
Module, MPWA, and all MPWA connectors (Stepper Motor, Servo
Motor, Fan, Display, Power Supply and Trailing Cable).
To remove the Right Cover Assembly:
1. Remove the Top Cover. Keep the right end of the Top Cover tilted
up so that the Retracting Stop and Compression Spring don’t fall
out.
2. You may find it helpful to wrap a rubberband around the connector
clips on the parallel port to hold them out of the way while the
Right Cover Assembly is being removed.
3. Move the Carriage Assembly to the middle of the Platen.