ENCAD T-200, Service Manual

Page: 146 / 162

ENCAD T-200 and T-200+ Service Manual
Assembly\Disassembly 5-44
11. Route the Display Cable through the top left edge in the Right Side
Plate. Bring the Display Cable down around the flat edge of the
MPWA. Connect the Display Cable at the J3 connector on the
MPWA. The silver fingers must face the back side of the
plotter when the Display Cable is inserted into the
connector.
12. Reconnect the Servo Motor wire (Red and Blue) to the J7 connector,
the Stepper Motor wire to the J10 connector, and the Fan wire (Red
and Black) to the J5 connector. Reference Figure 5-2.
13. Reinstall the Trailing Cable Cover.
14. Reinstall the Right Cover Assembly. Make sure that none of the
harnesses or cables are pinched between the cover assembly and the
Right Side Plate.
15. Reinstall the Left Cover.
16. Reinstall the Top Cover.
The entire plotter is now reassembled.
Removing the Upper Pinch Roller Supports
1. Remove the Top Cover and Left Cover.
2. Use the #1 Phillips Screwdriver to remove the 3 screws which
secure the Trailing Cable Cover to the back of the Y-Bracket and
remove the Trailing Cable Cover.
3. Depress the back of the Frame Tensioner (see Figure 5-6) and slip
the Carriage Belt off the Servo Motor Pulley. (The Carriage Belt
only needs to be loose during this procedure; it does not need to be
removed. Lift both sides of the Carriage Belt out of the Y-Bracket
and loop them over the front of the Slide Shaft.)
4. Use the #1 Phillips Screwdriver to remove the screws which hold
the far left Upper Pinch Roller Support on the Y-Bracket. (The
screws are located on the back of the Y-Bracket. See Figure 5-25.)
MAKE SURE YOU ARE LOOSENING THE CORRECT
SCREWS AND NOT THE ONES WHICH HOLD ON THE
STABILIZER BRACKET!