ENCAD T-200, Service Manual

Page: 72 / 162

ENCAD T-200 and T-200+ Service Manual
Maintenance 3-32
Adjustment of the Mounting Screws
Figure 3-24 shows how the motion (rapid drifting to the right or to the
left) of the roller determines which mounting screw should be tightened
in order to eliminate the motion of the roller so that the roller stays in
the center of the shaft and/or there is a gap when the Lower Roller is
rotated forward.
IF ROLLER MOVES
TO THE RIGHT
AND TOUCHES,
THEN TIGHTEN THE
LEFT MOUNTING SCREW
1/2 TURN AT A TIME.
IF ROLLER MOVES
TO THE LEFT
AND TOUCHES,
1/2 TURN AT A TIME.
RIGHT MOUNTING SCREW
THEN TIGHTEN THE
NO GAP NO GAP
ORIENTATION
STANDING BEHIND THE PLOTTER,
FACING THE BACK OF THE PLOTTER
Figure 3-24. Motion of Rollers and Adjustment of Mounting
Screws.
Once you have completed the adjustment of Rollers #8, #7, and #6,
adjust Rollers #5 and #4, following the same procedures. After Rollers
#5 and #4 are adjusted, adjust Rollers #3, #2, and #1, following the same
procedures.