ENCAD T-200, Service Manual

Page: 131 / 162

ENCAD T-200 and T-200+ Service Manual
Assembly\Disassembly 5-29
Reinstalling the Trailing Cable
1. Apply two new pieces of double sided tape to the Stabilizer Bracket.
Ensure that the tape is in the same location as the original tape
was. Do not remove the top protective cover on the tapes yet.
2. Place the Trailing Cable on the Stabilizer Bracket.
3. Route the right end of the Trailing Cable through the Right Side
Plate and connect the Trailing Cable connector at the J6 location
on the MPWA. Be sure to slide both sides of the connector lock
shut at the same time.
4. Insert the Trailing Cable into the Strain Relief Assembly. Insert
the Strain Relief (with Trailing Cable) onto the Carriage Assembly
by sliding it onto the Strain Relief Support until it snaps firmly
into place.
5. Connect the Trailing Cable to the J6 connector on the Carriage
PWA. Slide both sides of the connector lock shut at the same
time.
6. Press the Trailing Cable down onto the double-sided tape on the
Carriage PWA.
7. Move the Carriage Assembly to the very left end of the Slide Shaft.
8. Remove the top protective cover on the 2” double-sided tape on the
right end of the Stabilizer Bracket and press the right end of the
Trailing Cable onto the tape.
9. With the Carriage Assembly still at the very left end of the Slide
Shaft and with the Trailing Cable still in line remove the top
protective cover on the 2” double-sided tape in the center of the
Trailing Cable and press the Trailing Cable onto the tape.
10. Slide the Carriage Assembly back and forth several times to make
sure that the Trailing Cable does not catch on anything and to
make sure that the Carriage Assembly will travel the full length
of the Slide Shaft.
11. Reinstall the Electronics Cover and Right Cover Assembly. Also
reinstall the Trailing Cable Cover and Top Cover.