ENCAD T-200 and T-200+ Service Manual
Maintenance
3-30
Observation of Paper Skew at Rear Media Alignment Mark
1. Position a sheet of the appropriate size paper for loading. The
cut corner should be the top right corner of the paper as you
load it. Make sure the correct side is up against the rollers, and
the right-hand side is aligned with the Front Media Alignment
Mark on the front of the Platen.
NOTE
Make sure that there is no gap between the right edge of
the paper and the left edge of the Front Media Alignment
Mark on the Platen.
2. Hold the media and press LOAD. The paper will be pulled in
past the Platen’s groove. The paper will roll forward (out) and
stop.
3. Check to make sure that the gap between the right edge of the
paper and the left edge of the Rear Media Alignment Mark (on
back of the Platen) is within 2 line widths (0.12”). See Figure 3-
22.
PLOTTER'S REAR MEDIA ALIGNMENT MARK
(LOCATED ON THE BACK SIDE OF THE PLATEN)
LEFT
0.00" - 0.12"
PAPER SLEW ACCEPTANCE RANGE = TWICE
THE WIDTH OF THE MEDIA ALIGNMENT MARK
PAPER
RIGHT
PAPER
Figure 3-22. Paper Skew Acceptance Range for Rear Media
Alignment Mark.
Summary of Contents for T-200
