ENCAD T-200, Service Manual

Page: 132 / 162

ENCAD T-200 and T-200+ Service Manual
Assembly\Disassembly 5-30
Removing the Power Supply and ON/OFF Switch
NOTE
To gain access to all the screws that secure the Power
Supply to the Platen the left leg must be loosened and
turned or removed entirely from the Platen. To the left
leg assembly first remove the media basket. Then re-
move three screws and loosen the last screw (see Figure
5-18) that connects the left leg assembly to the platen.
While holding the plotter up, turn the leg assembly in a
clockwise direction to reveal the other two Power Supply
Assembly screws. Once the screws are revealed, tighten
the leg assembly to support the plotter.
1. Remove the Top Cover and the Left Cover.
2. Using a #2 Phillips screwdriver, remove the 4 screws on the bottom
of the Platen which hold the Power Supply in place.
3. Pull the Power Supply part way out of the Platen, grasp the
connector on the black and white ON/OFF Switch Cable, and
remove the cable from the Power Supply.
4. Pull the Power Supply the rest of the way out of the Platen, grasp
the connector on the Power Cable coming from the MPWA, and
remove the Power Cable from the Power Supply.
5. If the ON/OFF Switch needs to be replaced, push the top of the
switch out of the back of the Platen, pry up on the bottom of the
switch with a screwdriver (from inside the Platen), and push the
switch out of the Platen. Remove the ground wire from the Platen.