Emerson Rosemount CT5100 Ex, Quick Start Manual

Page: 20 / 86

8. In case extra security is required on the installation of the analyzer by thread locking
the fittings, it should only be performed with compounds compatible with the zone
classification of the installation location.
9. The four wall fixing points must be 10.5 mm diameter mounting holes.
10. Make sure that the wall fixing points are capable of supporting a load of 110 kg (242
lb) each; this includes a x 2 factor of safety. Figure 1-5 shows the locations of the
mounting points on the analyzer. All mounting points are 10.5 mm diameter holes.
11. Make sure the bolts are secure. Do not over tighten the fasteners.
12. The analyzer must be mounted using the four off factory fitted and pre-drilled holes
on the brace bars. Refer to Figure 1-3 .
13. The lifting eyes are to be removed and retained for future use. Threads must be
protected with a suitable grease and plastic grommets.
After mounting, no additional load is to be placed on the analyzer.
14. Do not place or leave loose items on flat surfaces.
15. For transportation, the purge vent (D) located on the base of the analyzer is fitted
with a temporary protector cap (C). This protector cap MUST remain in place until
the analyzer is going to be commissioned. Refer to Figure 1-4 .
The vent cap (A), O-ring (E) and grub screws (B) are shipped loose in the crate. Refer
to
Figure 1-3 .
Figure 1-4: Connecting the Purge Vent Cap
A. Vent cap
B. 3/32 in. socket grub screws
C. Protector cap
D. Purge vent
E. O-ring
Introduction Quick Start Guide
August 2018 D-7010-0055
20 Rosemount
™
CT5100 Ex