EMC DL3D 1500, Administrator'S Manual

Page: 49 / 238

Configuring SNMP 49
Configuring DL3D 1500/3000
5. Click Apply to save the destination information.
Note: Appendix A lists warning and failure events.
Community
Use the Community page to add, edit, and delete the SNMP
community information.
1. Click Add in the Community area.
2. In Add SNMP Community, type the new community
information:
• A unique name in the Name field; the field holds up to 20
characters (a-z, A-Z) with no special characters or blank
spaces.
CAUTION
!
If no communities are defined, the DL3D appliance is
universally accessible through a “public” community (read
only).
• IP address in the IP Address field; if the value in the Network
Mask
edit box ends in a zero, the value in the IP address edit
box must also end in a zero.
Note: An IP address of 0.0.0.0 will disable the IP address access
control for the community. Similarly, a zero in the octet of the IP
address (and corresponding network mask octet) will allow access
for the entire range of addresses in that part of the IP address. If not
disabled, the source address of an SNMP request is logically ANDed
Failure Generates a trap on system-detected errors.
Available Generates a trap every time the library transitions from an
unavailable to an available state.
Unavailable Generates a trap every time the library transitions from an available
to an unavailable state.
Table 2
SNMP trap selections (continued)
Field Description