SMG digital gateway
103
Optional Attributes of Authentication-Request Packets
NAS-Port-Type
—NAS physical port type (a server for user authentication), the default value is
Async.
Service-Type
—type of the service, not used by default (Not Used).
Framed-protocol
—the protocol specified for packet access utilisation, not used by default (Not
Used).
RADIUS-Accounting settings
Send Requests
accounting-start
—sends an
accounting
start packet that notifies the RADIUS server on call start.
accounting-stop
—sends an
accounting
stop packet that notifies the RADIUS server on call end.
accounting-stop for unsuccessful calls
—sends information on unsuccessful calls to the RADIUS
server.
accounting-update with period
—during a call, periodically sends an
update
packet to the RADUIS
server to notify the RADIUS server on active state of the call.
accounting
for call-origin=answer—
sends information about the outgoing part of a call to the
RADIUS server.
The
Call Origin
field in case of CISCO—sends "
answer"
for the incoming part of a call, and "
originate
" for
the outgoing part.
In case of a server fault (no response from the server), the outgoing communications can be restricted:
no restrictions—allows all calls;
local and zone networks only—allows calls to special services, local and zone network;
local network only—allows calls to special services and local network;
emergency only—allows calls to special services only;
deny all—denies all calls.
This restriction governs call routing by a prefix controlling the corresponding call type (local, long-
distance, etc.).
USERNAME field—the
selected User-Name value in an Accounting Request packet (RADIUS
-
Accounting):
–
CgPN—
uses the calling party phone number as the value;
–
IP or E1-stream—
uses the calling party IP address or incoming connection stream number
as the value;
–
Trunk name—
uses incoming connection trunk name as the value.
CdPN field—
the selected value of the callee number used for RADIUS packet generation for
specific Attribute-Value pairs (see section 4.1.13.3):
–
CdPN-in
—uses the callee number prior to modification (the number received in the
SETUP/INVITE packet);
–
CdPN-out
—uses the callee number after modification.
CgPN field—the selected value of the caller number to be used for RADIUS packet generation for
certain Attribute-Value pairs (see section 4.1.13.3):
–
CgPN-in
—uses the caller number prior to modification (the number received in the
SETUP/INVITE packet).
–
CgPN-out
—uses the caller number after modification.