ELTEX LTP-4X, Operation Manual

Page: 86 / 199

86
The channel-group command can be executed in the config view of an interface (a range)
of the switch.
Step 9. This step should only be performed for LACP configuration. Set a priority for a physical interface
with the help of the lacp port-priority command if necessary. The no lacp port-priority command resets port
priority to the default value of 32768; 1 is the highest priority.
LTP-8X(switch)(config-if-range)# no lacp port-priority
LTP-8X(switch)(config-if-range)# exit
LTP-8X(switch)(config)# interface front-port 0
LTP-8X(switch)(config-if)# lacp port-priority 256
The lacp port-priority command can be executed in the config view of a switch
interface.
Step 10. This step should only be performed for LACP configuration. Use the lacp mode command to set
an active or passive LACP mode.
LTP-8X(switch)(config-if)# exit
LTP-8X(switch)(config)# interface port-channel 3
LTP-8X(switch)(config-if)# lacp mode active
Step 11. This step should only be performed for LACP configuration. In case of the active LACP mode, set
an interval for transmission of LACP control packets with the help of the lacp rate command. Pass slow (30
seconds) or fast (1 second) as a parameter.
LTP-8X(switch)(config-if)# lacp rate slow
Step 12. Apply the configuration by using the commit command.
LTP-8X(switch)(config-if)# exit
LTP-8X(switch)(config)# commit