ELTEX LTP-4X, Operation Manual

Page: 51 / 199

51
LTP-8X# configure terminal
LTP-8X(config)# no aaa accounting commands
In case server configured for a function unavailable or key is not defined properly, the
function will be implemented locally.
Chapter 14.
Services Configuration
Introduction
This chapter describes configuration of integrated terminal services.
14.1 SNMPD Configuration
To work with the Eltex.EMS management system, the terminal should be configured to work with Simple
Network Management Protocol (SNMP).
Step 1. Switch to the configure view.
LTP-8X# configure terminal
Step 2. Enable the SNMP agent of the terminal by using snmp enable command.
LTP-8X(config)# ip snmp enable
Step 3. Enable ACL check by using snmp access-control command if necessary. Add the record into the
whitelist by using snmp allow command. Pass the IP address of the host which will be used to connect to the
SNMP agent, as a parameter.
LTP-8X(config)# ip snmp access-control
LTP-8X(config)# ip snmp allow ip 192.168.1.13