ELTEX LTP-4X, Operation Manual

Page: 44 / 199

44
Chapter 12.
User Management
Introduction
This chapter is devoted to management of the terminal users.
Proper operation of the inband management function requires VLAN adjustment in
the switch view as described in Chapter 15.
The factory settings provide only one user, i. e. the device administrator.
login: admin
password: password
When you start to configure the terminal, we recommend you to change the password of
the "admin" user.
For security reasons, there is a strictly defined set of permissions, which can be delegated to terminal
users. For these purposes, each user gets his own level of privileges. Level 0 corresponds to a minimum set of
permissions, Level 15—to a maximum set of permissions.
CLI commands are ranked by the level of privileges. Level 0 commands are available to all users. Level 15
commands are available only to Level 15 users. Thus, the level of commands available to a user does not
exceed the user's level.
The levels of privileges can be modified as required.
Step 1. Check the current settings of privileges by using the show privileges command.
LTP-8X# show privileges
Level Privileges
0 !, exit
1 view-ont
2 ont-operation
3 view-ont, ont-operation
4 view-ont, config-ont
ont-operation
5 view-gpon, view-ont
view-ont-profile, ont-operation