Mounting
9
© Gardner Denver Deutschland GmbH
41
/
60
09.2013 · 610.44495.40.310
Fitting the compressor cover
▪
Fill the cavity of the bearing mount in the compressor cover (030) with
grease
,
according to the following table.
Motor size
[g]
[oz]
2BH20360-1
21.6 – 25.0
0.726 – 0.881
2BH20540-1
26.3 – 30.4
0.927 – 1.072
2BH20780-1
56.2 – 64.8
1.983 – 2.285
▪
Turn the locating pin (X) into the bearing cover (010) and mount the compres-
sor cover (030) on the locating pin.
NOTICE! Note the position of the compressor cover (030) with respect to
the compressor housing (002).
▪
Screw the compressor cover (030) to the compressor housing (002) using the
screws (074).
▪
Screw the bearing cover (010) and compressor cover (030) using the screw
(014).
Remove the locating pin (X) before fitting the last screw.
9.7
Prematic AG, Märwilerstrasse 43, 9556 Affeltrangen www.prematic.ch
Tel. 071 918 60 60, Mail: [email protected]