9
Mounting
610.44495.40.310 · 09.2013
40
/
60
© Gardner Denver Deutschland GmbH
Assembling the rolling bearing on the compressor side
▪
Push the end plate (010) onto the rotor (005) in the marked installation posi-
tion.
▪
Fill the cavity in the compressor side rolling bearing (007) with
grease
, accord-
ing to the following table.
Type
[g]
[oz]
2BH20360-1
5.0 – 6.1
0.176 – 0.215
2BH20540-1
7.1 – 8.6
0.251 – 0.303
2BH20780-1
17.1 – 20.9
0.603 – 0.737
▪
Grease
the washer (069) on both sides and put onto the screw (029)
▪
Fit the washer (078) onto the screw (029) in the marked installation position.
▪
Grease
the inner ring of the rolling bearing (007) and bearing seat of the shaft
(005).
▪
Put
medium strength threadlocker
onto the thread of the screw (029).
▪
NOTICE! Note the installation position of the rolling bearing (007), the
open side facing up (in the direction of the compressor cover)
▪
Tighten the rolling bearing (007) with screw (029).
9.6
Prematic AG, Märwilerstrasse 43, 9556 Affeltrangen www.prematic.ch
Tel. 071 918 60 60, Mail: [email protected]