Electrolux ICON Professional E30DF74GPS, Design Manual

Page: 158 / 164

158
planning
information
For models:
Cooktop
E30GC70FSS
E36GC70FSS
Single Wall Oven
E30EW75GPS
E30EW75GSS
Note: For planning
purposes only. Refer
to Product Installation
Guide on the web at
electroluxicon.com for
detailed instructions.
Specifications subject
to change.
project planning
Gas Cooktop Installation Over 30" Electric Single Wall Oven
Installation Specifications
30" Electric Single Wall Oven
Under-Counter Installation Specifications
• Product Weights –
(E30EW75GPS) 178 Lbs. / (E30EW75GSS) 175 Lbs.
• Single phase 3- or 4-wire cable, 120 / 240 or 120 / 208
Volt, 60 Hertz AC only electrical supply with ground
required on separate circuit fused on both sides of line.
• Connected Load (kW Rating) @ 240 / 208 Volts =
4.0 / 3.0 kW
• Amps @ 240 / 208 Volts = 16.6 / 14.4 Amps
• Always consult local and national electric and gas codes.
• Minimum 23-1/4" clearance for oven door depth
when open.
• Minimum 24" deep cutout dimension is critical for
proper installation, to ensure that oven’s faceplate will fit
flush against cabinet front.
• Full oven base of solid plywood or similar material required,
capable of supporting 200 Lbs. Install over two runners
and flush with toe plate.
• Base must be level and cabinet front must be square
with finish-cut bottom edge.
• Side filler panels necessary to isolate oven from adjoining
cabinets.
• Allow 5" maximum height from oven base to floor, if NO
cooktop is installed directly over wall oven.
Gas Cooktop Installation Over
30" Electric Single Wall Oven Specifications
Electrolux ICON
®
Single Wall Oven models E30EW75GPS
and E30EW75GSS are approved to be used beneath
Electrolux ICON ® gas cooktop models E36GC70FSS and
E30GC70FSS (gas cooktop models NOT approved for
use in this installation are E36GC75GSS, E48GC76EPS,
E36GC76GPS and E30GC74GPS)
.
For detailed Gas Cooktop installation, refer to model-specific
Planning Information page and installation guide on web.
• Side filler panels necessary to isolate oven from adjoining
cabinets. Panel height may need to be modified to accom-
modate the depth of approved gas cooktop models.
• Minimum height opening of 6-1/2" (from top of counter)
required in right cabinet side panel and/or filler panel, to
route gas and electric hookups.
• Allow 4-1/2" maximum height from oven base to floor,
if cooktop is installed directly over wall oven.
Combination Gas Cooktop/Electric Wall Oven
Under-Counter Installation
Electric Single Wall Oven Cutout
For models: E30EW75GPS
& E30EW75GSS
For all approved gas cooktop models, a minimum
height opening of 6-1/2" (from top of counter) required
in right cabinet side panel and/or filler panel, to route
gas and electric hookups. (Refer to Gas Cooktop
Utility Hookup Diagram)
Oven cutout
120V/60Hz
grounded
outlet, for
gas cooktop
Cooktop
cutout**
28
1
/
2
" min.
28
7
/
8
" max.
240/208V
Junction box
for wall oven
Approx. 3"
24" min.
cutout depth
To route armored cable to junction box through left cabinet side panel
and/or filler panel, cut minimum 4" x 4" opening in wood base and runner
*Critical dimension – MUST be applied
**For cooktop cutout dimensions refer to model-specific
product page or installation guide on web
5"
6 1 /
2
"
min.
Pressure regulator
Manual shutoff valve
(Must be accessible)
Cabinet sides
and/or filler panel
Flare union
Manifold
pipe
Flexible connector
Flare
union
4"
Countertop
18"max.
120V/60Hz
grounded outlet
Cooktop
Gas
Cooktop
Utility
Hookup
Side filler panels necessary to isolate oven from
adjoining cabinets. Panel height may need to
be modified to accommodate the depth of approved
gas cooktop models
4-1/2" maximum height allowed
from oven base to floor if cooktop
is installed directly over wall oven.
(5" maximum height allowed
with no cooktop.)
Side View
Cooktop
Wall Oven
36"
min.
Unit will overlap cutout (minimum) edges by 1"
Install
3
/
4
" full plywood base on 2 runners, flush
with toe plate, capable of supporting 200 lbs.
24"min.*
28
1
/
2
"min.
29"max.