
Index
– 929 –
remote ID
sub-length field
sub-option format
sub-type and sub-length, disabling
subtype field
DHCPv6 snooping
enabling
global configuration
remote id policy, option 37
remote ID, option 37
specifying trusted interfaces
trusted port
untrusted port
VLAN configuration
DiffServ
binding policy to interface
class map
class map, description
classifying QoS traffic
color aware, srTCM
color aware, trTCM
color blind, srTCM
color blind, trTCM
committed burst size
committed information rate
,
configuring
conforming traffic, configuring response
description
excess burst size
metering, configuring
peak burst size
peak information rate
policy map
policy map, description
QoS policy
service policy
setting CoS for matching packets
setting IP DSCP for matching packets
setting PHB for matching packets
single-rate, three-color meter
srTCM metering
traffic between CIR and BE, configuring response
traffic between CIR and PIR, configuring response
trTCM metering
two-rate, three-color meter
violating traffic, configuring response
DNS
default domain name
displaying the cache
domain name list
domain names appended
enabling lookup
name server list
static entries, IPv4
static entries, IPv6
See
DNS
domain service access point, CFM
downloading software
automatically
using FTP or TFTP
drop precedence
CoS priority mapping
DSCP ingress map
DSA encryption
DSCP
enabling
mapping to internal values
DSCP ingress map, drop precedence
DSCP to PHB/drop precedence
dynamic addresses
clearing
displaying
Dynamic Host Configuration Protocol
See
DHCP
dynamic QoS assignment
dynamic VLAN assignment
E
edge port, STA
encryption
DSA
RSA
engine ID
ERPS
configuration guidelines
control VLAN
domain configuration
domain, enabling
forced mode
global configuration
guard timer
hold-off timer
major domain
manual mode
MEG level
node identifier
node state
node type
non-compliant device protection
propagate topology change
R-APS default MAC
R-APS with virtual channel
revertive recovery
ring configuration
ring port, east interface
ring port, west interface
ring, enabling
RPL neighbor
Summary of Contents for ECS4120-28F
