Edge-Core ECS4120-28F, Reference Manual, Page: 426 / 938

Chapter 12
| Link Aggregation Commands
– 426 –
Guidelines for Creating Trunks
General Guidelines –
◆
Finish configuring trunks before you connect the corresponding network
cables between switches to avoid creating a loop.
◆
A trunk can have up to 26 ports.
◆
The ports at both ends of a connection must be configured as trunk ports.
◆
All ports in a trunk must be configured in an identical manner, including
communication mode (i.e., speed and duplex mode), VLAN assignments, and
CoS settings.
◆
When using an LAG composed of all 10G ports, different transceiver types may
be used as long as the speed of each member port is the same.
◆
Any of the Gigabit ports on the front panel can be trunked together, including
ports of different media types.
◆
All the ports in a trunk have to be treated as a whole when moved from/to,
added or deleted from a VLAN via the specified port-channel.
◆
STP, VLAN, and IGMP settings can only be made for the entire trunk via the
specified port-channel.
Dynamically Creating a Port Channel –
Ports assigned to a common port channel must meet the following criteria:
◆
Ports must have the same LACP system priority.
◆
Ports must have the same port admin key (Ethernet Interface).
◆
If the port channel admin key ( lacp admin key - Port Channel) is not set when a
channel group is formed (i.e., it has the null value of 0), this key is set to the
same value as the port admin key (
lacp admin key - Ethernet Interface) used by
the interfaces that joined the group.
◆
However, if the port channel admin key is set, then the port admin key must be
set to the same value for a port to be allowed to join a channel group.
◆
If a link goes down, LACP port priority is used to select the backup link.