Edge-Core ECS4120-28F, Reference Manual, Page: 775 / 938

Chapter 26
| CFM Commands
– 775 –
Basic Configuration Steps for CFM
1.
Configure the maintenance domains with the ethernet cfm domain command.
2.
Configure the maintenance associations with the ma index name command.
3.
Configure the local maintenance end points (MEPs) which will serve as the
domain service access points for the specified maintenance association using
the
ethernet cfm mep command.
ethernet cfm mep
crosscheck Enables cross-checking between the list of configured
remote MEPs within a maintenance association and MEPs
learned through continuity check messages PE
show ethernet cfm
maintenance-points
remote crosscheck Displays information about remote maintenance points
configured statically in a cross-check list PE
Link Trace Operations
ethernet cfm linktrace
cache Enables caching of CFM data learned through link trace
messages GC
ethernet cfm linktrace
cache hold-time Sets the hold time for CFM link trace cache entries GC
ethernet cfm linktrace
cache size Sets the maximum size for the link trace cache GC
ethernet cfm linktrace Sends CFM link trace messages to the MAC address for a
MEP PE
clear ethernet cfm
linktrace-cache Clears link trace messages logged on this device PE
show ethernet cfm
linktrace-cache Displays the contents of the link trace cache PE
Loopback Operations
ethernet cfm loopback Sends CFM loopback messages to a MAC address for a MEP
or MIP PE
Fault Generator Operations
mep fault-notify alarm-time Sets the time a defect must exist before a fault alarm is
issued CFM
mep fault-notify lowest-
priority Sets the lowest priority defect that is allowed to generate a
fault alarm CFM
mep fault-notify reset-time Configures the time after a fault alarm has been issued, and
no defect exists, before another fault alarm can be issued CFM
show ethernet cfm fault-
notify-generator Displays configuration settings for the fault notification
generator PE
Delay Measure Operations
ethernet cfm delay-
measure two-way Sends periodic delay-measure requests to a specified MEP
within a maintenance association PE
Table 157: CFM Commands
(Continued)
Command Function Mode