Edge-Core ECS4120-28F, Reference Manual, Page: 882 / 938

Chapter 30
| IP Interface Commands
IPv6 Interface
– 882 –
processes are disabled on the interface. If a duplicate global unicast address is
detected, it is not used. All configuration commands associated with a
duplicate address remain configured while the address is in “duplicate” state.
◆
If the link-local address for an interface is changed, duplicate address detection
is performed on the new link-local address, but not for any of the IPv6 global
unicast addresses already associated with the interface.
Example
The following configures five neighbor solicitation attempts for addresses
configured on VLAN 1. The
show ipv6 interface command indicates that the
duplicate address detection process is still on-going.
Console(config)#interface vlan 1
Console(config-if)#ipv6 nd dad attempts 5
Console(config-if)#end
Console#show ipv6 interface
VLAN 1 is up
IPv6 is enabled.
Link-local address:
fe80::269:3ef9:fe19:6779%1/64
Global unicast address(es):
2001:db8:0:1:2e0:cff:fe02:fd/64, subnet is 2001:db8:0:1::/64[EUI]
2001:db8:2222:7272::72/96, subnet is 2001:db8:2222:7272::/96
Joined group address(es):
ff02::2
ff02::1:ff19:6779
ff02::1:ff00:0
ff02::1:ff00:72
ff02::1:ff02:fd
ff02::1:2
ff02::1
IPv6 link MTU is 1500 bytes
ND DAD is enabled, number of DAD attempts: 5.
ND retransmit interval is 1000 milliseconds
ND advertised retransmit interval is 0 milliseconds
ND reachable time is 30000 milliseconds
ND advertised reachable time is 0 milliseconds
ND advertised router lifetime is 1800 seconds
Console#
Related Commands
ipv6 nd ns-interval (883)
show ipv6 neighbors (886)