Edge-Core ECS4120-28F, Reference Manual, Page: 51 / 938

Chapter 1
| Initial Switch Configuration
Configuring the Switch for Remote Management
– 51 –
Configuring the Switch for Remote Management
The switch can be managed through the operational network, known as in-band
management. Because in-band management traffic is mixed in with operational
network traffic, it is subject to all of the filtering rules usually applied to a standard
network ports such as ACLs and VLAN tagging. In-band network management can
be accessed via a connection to any network port (1-28/52).
Setting an IP Address
You must establish IP address information for the switch to obtain management
access through the network. This can be done in either of the following ways:
◆
Manual — You have to input the information, including IP address and subnet
mask. If your management station is not in the same IP subnet as the switch,
you will also need to specify the default gateway router.
◆
Dynamic — The switch can send IPv4 configuration requests to BOOTP or
DHCP address allocation servers on the network, or can automatically generate
a unique IPv6 host address based on the local subnet address prefix received in
router advertisement messages. An IPv6 link local address for use in a local
network can also be dynamically generated as described in
“Obtaining an IPv6
Address” on page 55 .
The current software supports DHCP for IPv6, so an IPv6 global unicast address
for use in a network containing more than one subnet can be obtained through
the DHCPv6 server, or manually configured as described in
“Assigning an IPv6
Address” on page 52 .
Manual Configuration
You can manually assign an IP address to the switch. You may also need to specify a
default gateway that resides between this device and management stations that
exist on another network segment. Valid IPv4 addresses consist of four decimal
numbers, 0 to 255, separated by periods. Anything outside this format will not be
accepted by the CLI program.
Note: The IPv4 address for VLAN 1 is obtained via DHCP by default.
Assigning an IPv4 Address
Before you can assign an IP address to the switch, you must obtain the following
information from your network administrator:
◆
IP address for the switch
◆
Network mask for this network
◆
Default gateway for the network