Edge-Core ECS4120-28F, Reference Manual, Page: 81 / 938

Chapter 2
| Using the Command Line Interface
Entering Commands
– 81 –
To enter the Global Configuration mode, enter the command configure in
Privileged Exec mode. The system prompt will change to “Console(config)#” which
gives you access privilege to all Global Configuration commands.
Console#configure
Console(config)#
To enter the other modes, at the configuration prompt type one of the following
commands. Use the
exit or end command to return to the Privileged Exec mode.
Table 4: Configuration Command Modes
Mode Command Prompt Page
Access
Control List access-list arp
access-list ip standard
access-list ip extended
access-list ipv6 standard
access-list ipv6 extended
access-list mac Console(config-arp-acl)
Console(config-std-acl)
Console(config-ext-acl)
Console(config-std-ipv6-acl)
Console(config-ext-ipv6-acl)
Console(config-mac-acl) 378
362
362
368
368
373
CFM ethernet cfm domain Console(config-ether-cfm) 779
Class Map class-map Console(config-cmap) 622
ERPS erps domain Console(config-erps) 525
Interface interface {ethernet port | port-channel id |
vlan id }
Console(config-if ) 387
Line line {console | vty} Console(config-line) 134
MSTP spanning-tree mst-configuration Console(config-mstp) 502
Policy Map policy-map Console(config-pmap) 625
Time Range time-range Console(config-time-range) 168
VLAN vlan database Console(config-vlan) 562