Edge-Core ECS4120-28F, Reference Manual, Page: 89 / 938

Chapter 3
| General Commands
– 89 –
Default Setting
None
Command Mode
Global Configuration
Command Usage
◆
This command resets the entire system.
◆
Any combination of reload options may be specified. If the same option is re-
specified, the previous setting will be overwritten.
◆
When the system is restarted, it will always run the Power-On Self-Test. It will
also retain all configuration information stored in non-volatile memory by the
copy running-config startup-config command (See “copy” on page 122 ).
Example
This example shows how to reset the switch after 30 minutes:
Console(config)#reload in minute 30
***
*** --- Rebooting at January 1 02:10:43 2015 ---
***
Are you sure to reboot the system at the specified time? <y/n>
enable
This command activates Privileged Exec mode. In privileged mode, additional
commands are available, and certain commands display additional information.
See
“Understanding Command Modes” on page 78 .
Syntax
enable [ level ]
level - Privilege level to log into the device.
The device has two predefined privilege levels: 0: Normal Exec,
15: Privileged Exec. Enter level 15 to access Privileged Exec mode.
Default Setting
Level 15
Command Mode
Normal Exec
Command Usage
◆
“super” is the default password required to change the command mode from
Normal Exec to Privileged Exec. (To set this password, see the
enable password
command.)