Edge-Core ECS4120-28F, Reference Manual, Page: 514 / 938

Chapter 19
| Spanning Tree Commands
– 514 –
spanning-tree
loopback-detection
trap
This command enables SNMP trap notification for Spanning Tree loopback BPDU
detections. Use the
no form to restore the default.
Syntax
[ no ] spanning-tree loopback-detection trap
Default Setting
Disabled
Command Mode
Interface Configuration (Ethernet, Port Channel)
Example
Console(config)#interface ethernet 1/5
Console(config-if)#spanning-tree loopback-detection trap
spanning-tree mst
cost
This command configures the path cost on a spanning instance in the Multiple
Spanning Tree. Use the
no form to restore the default auto-configuration mode.
Syntax
spanning-tree mst instance-id cost cost
no spanning-tree mst instance-id cost
instance-id - Instance identifier of the spanning tree. (Range: 0-4094)
cost - Path cost for an interface. (Range: 0 for auto-configuration, 1-65535
for short path cost method
21
, 1-200,000,000 for long path cost method)
The recommended path cost range is listed in Table 98 on page 509 .
Default Setting
By default, the system automatically detects the speed and duplex mode used on
each port, and configures the path cost according to the values shown below. Path
cost “0” is used to indicate auto-configuration mode. When the short path cost
method is selected and the default path cost recommended by the IEEE 8021w
standard exceeds 65,535, the default is set to 65,535. The default path costs are
listed in
Table 99 on page 509 .
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
◆
Each spanning-tree instance is associated with a unique set of VLAN IDs.
◆
This command is used by the multiple spanning-tree algorithm to determine
the best path between devices. Therefore, lower values should be assigned to
21. Use the spanning-tree pathcost method command to set the path cost method.