Ecom ECP2010, User Manual

Page: 16 / 68

ECP2010 / ECP2010H
16 / 68
4.6. Assemblage of Waste System
The pump is equipped with waste channel, leading the liquid off the pumping block. In its
proximity is leakage sensor. The function of the sensor is closely described in chapter 6.2.7 , in
chapter 6.4.3.4 is described the setting of
IO INTERFACE Digital Out Switch – LEAKAGE
signalizing the leakage of pump to another unit. In chapter 6.6.5 is displayed the status of IO
INTERFACE
and in chapter 6.6.6 is shown the leakage sensor status.
W
ASTE
S
ET
ECP2010
1. Silicone tubing 2 m with connector Y and I; 2. Connector Y with two pieces of silicone tubing;
3. Connectors L into the drain channel.
The pump is usually a part of a system, together with other units. Connection of waste
system can be adjusted according to given system.
One possible system is pump with box . Among box accessories is T connector, one end
should be pushed into the box drain channel (see picture below). Second end should be connected
with longer tubing of part 2 (see picture above) and third end may be used i.e. for waste tubing
from injection valve.