Eclipse GEO3.5, User Manual, Page: 6 / 86

6 GEO3.5 MANUAL
FACTORY SET-UP GUIDE
WARNING!
De-gas your marker, discharging any stored gas in a safe direction, and
remove the barrel, loader, air system and any paintballs to make the marker
easier and safer to work on.
WARNING
Before using the GEO3.5 it is important to make sure the SL4 inline regulator,
solenoid flow restrictor (SFR) and all electronically controlled parameters are set
correctly. ANY of these can have a negative effect on the performance of the
marker if set incorrectly.
The steps below will restore the GEO3.5 settings to the factory settings. These
settings will give the GEO3.5 a more balanced performance, ideal for most users.
Inline Regulator Output Pressure
Check the inline regulator adjuster screw is set to 41/2 turns clockwise from its
maximum out position (see figure 1A) . This will ensure the SL4 inline regulator
is set to an output pressure that will not damage the GEO3.5 when supplied
with compressed air/nitrogen (see page 18 for more information on SL4 inline
regulator adjustment).
Solenoid Flow Restrictor Settings
Check that the solenoid flow restrictor (see figure 1B) is set as pictured. See
page 19 for more information on the solenoid flow restrictor.
Electronically Controlled Parameters
Load the FACTORY PRESET (see figure 1C) stored on the GEO3.5 circuit board.
This pre-set will restore all the electronic parameters to their default settings.
See page 29 on loading the FACTORY PRESET.
FIG 1A
FIG 1B
FIG 1C
+
+
_
_