Eclipse GEO3.5, User Manual, Page: 54 / 86

54 GEO3.5 MANUAL
THE TRIGGER ASSEMBLY
Having removed the frame completely from the GEO3.5 body (see page 51).
Unscrew the two M2.5x5 retaining screws which hold the bearing carrier in the
frame (see figure 24A) .
Gently lift the bearing carrier and trigger assembly free from the frame taking
care not to damage the micro-switch or the OPTO sensors (see figure 24B) .
Remove the trigger spring from the bearing carrier, removing any paint or
moisture (see figure 24C) .
Using a 1/16” hex key, loosen the trigger pin retaining set screw from the back
of the trigger (see figure 24D) .
Use a small hex key to push the trigger pin out of the bearing carrier from
one side (see figure 24E) , then remove the bearing carrier from the trigger
(see figure 24F) .
Clean the trigger and bearing carrier thoroughly and also clean the space within
the frame that the trigger sits in.
WARNING!
Always de-gas your marker, discharging any stored gas in a safe direction,
and remove the barrel, loader, air system and any paintballs to make the
marker easier and safer to work on.
WARNING
FIG 24A FIG 24B
FIG 24C FIG 24D
FIG 24E FIG 24F