2 Installation
2.1 Mounting the XN300 slice modules
20
XN300 slice modules
06/16 MN050002 EN
www.eaton.com
To mount the system on the DIN-rail, join the XN 300 slice modules and the
gateway to form a system block and then snap the entire system block onto
the DIN-rail.
To mount the system block, follow the steps below:
▶
The gateway must be the first element on the left in the system block.
▶
Disengage the side locking tabs on the XN300 slice modules by pulling
on the front cover (blue). Make sure that all the locking tabs (blue) are
pulled forward so that they will be able to engage the corresponding
slice module(s). The front cover's stay-put function is intended to make
this easier.
▶
Attach an XN300 slice module from the right in such a way that the lock-
ing tabs engage the guide.
Figure 2:
Joining the gateway and an XN300 slice module to form a system block
▶
Grab the front cover from the top and bottom and push it back towards
the XN300 slice module so that the slice modules lock solidly into place
with each other.
a
b
c
ϑ
30 mm
(1.18“)
30 mm
(1.18“)
100 mm
(3.94“)
≦
55 °C
(
≦
131 °F)
￫
The gateway's front cover is non-detachable and cannot be
removed.
1
2
2
2
1
Summary of Contents for XN300
Page 4: ...II...
Page 14: ...10 XN300 slice modules 06 16 MN050002 EN www eaton com...
