30 DC motor driver module XN-322-1DCD-B35
30.3 Wiring
238
XN300 slice modules
06/16 MN050002 EN
www.eaton.com
30.3 Wiring
Figure 124:
Diagram version 2: Wiring example for XN-322-1DCD-B35
The connection to PE is established with a DIN-rail contact at the bottom of
the module.
30.3.1 Connecting the power supply for the module
The module and the LED drivers are powered through connection terminal
X3. The two GND pins and the two 24 pins are internally linked.
30.3.2 Motor connection
The connection cables for the motor power supply need to be connected to
connector X1 with the output voltage for the motor.
The module can be used to control the motor's speed, output, and operating
direction. To make sure you use the right operating direction, make sure to
connect the motor with the right polarity.
30.3.3 Connecting LEDs
The LEDs are driven with a PWM controlled current source.
24 V DC
PE
0 V
V+ 0V M+ M-
1+ 1- 2+ 2-
24 24
X1
X3
X2
0V 0V
F1
12 - 30 V
0 V
U
eV+
+
-
M
I>
I
V+
U
e24
NOTICE
The rated uninterrupted current should not exceed 3.5 A.
→
Please make sure to use the right polarity when connecting the
LEDs.
Summary of Contents for XN300
Page 4: ...II...
Page 14: ...10 XN300 slice modules 06 16 MN050002 EN www eaton com...