Eaton Network-M3, User Manual

Page: 223 / 294

Installing the EMP
Servicing the EMP – 223
•
•
•
•
•
6.3.3 Cabling the first EMP to the device
6.3.3.1 Available Devices
Unable to render include or excerpt-include. Could not retrieve page.
Unable to render include or excerpt-include. Could not retrieve page.
6.3.3.2 Connecting the EMP to the device
6.3.3.2.1 Material needed:
EMP
RJ45 female/female connector (supplied in EMP accessories)
USB to RS485 converter cable (supplied in EMP accessories)
Ethernet cable (not supplied).
Device
6.3.3.2.2 Connection steps
STEP 1 – Connect the "USB to RS485 converter cable" to the USB port of the Device.
STEP 2 – Connect the "USB to RS485 converter cable" to the RJ45 female/female connector.
STEP 3 – Connect the Ethernet cable to the other end of the RJ45 female/female connector.
STEP 4 – Connect the other end of the Ethernet cable to the RJ-45 port on the EMP (FROM DEVICE).
Address must be defined before the EMP power-up otherwise the changes won't be taken into account.
Do not set Modbus address to 0, otherwise the EMP will not be detected.
Use the supplied tie wraps to secure the "RS485 to USB cable" to the Network cable.