Dynapro Technologies Dynapro ET TCS, Application Developer'S Manual

Page: 234 / 337

6-44
<Pch> is a numeric parameter that specifies the decimal value of the character to be used for
filling the area specified.
If <Pch> is omitted, the default value 251 from within the Extended Character Set is
used (the gray block character when the Static Special Character Font is mapped into the
Extended Character Set).
If <Pch > is greater than 255, 255 is used.
3266,%/((55256
Undesirable results may be produced if the Fill a Touchkey With a Character command is
executed on a touchkey that contains mixed line types.
(;$03/(
<ESC>
[3
x
Fills the entire screen with the gray block character (value 251 when the Static Special
Character Font is mapped into the Extended Character Set).
<ESC>[3;53
;
2;42x
Puts the asterisk (*) character (value 42 when the Static ASCII Character Font is mapped
into the Standard Character Set) in every character position of the border of Touchkey 53.
NOTE
These examples assume that the Static ASCII Character Font and the Static Special Character Font are
mapped into the Standard and Extended Character Sets, respectively. If this is not the case, the character
that fills the region may differ from the above examples (it may be a custom character).