Dynapro Technologies Dynapro ET TCS, Application Developer'S Manual

Page: 142 / 337

5-55
(UDVHLQ/LQH&RPPDQG>(/@5HPRWH
The Erase in Line command erases a specified chapter of the line occupied by the cursor.
Each character erased is replaced by a blank (the ASCII Space character) with character
attributes "off." The cursor does not move when the TCS executes this command.
NOTE
If the NOCHANGE Attribute Mode is set, erased characters are replaced with blanks, but their character
attributes remain unchanged. This makes it easier to erase within a field of attributes. The line type
remains unchanged regardless of the state of the NOCHANGE Attribute Mode.
23(5$72586$*(
None. (This is a remote command only.)
+26786$*(
<ESC> [<Ps>K
<Ps> is a selective parameter, specifying the portion of the current line to be erased.
If <Ps> is 0 or is omitted, characters from the cursor through the end of the line are
erased.