Dynapro Technologies Dynapro ET TCS, Application Developer'S Manual

Page: 267 / 337

8-14
5HTXHVW5207HVW5HSRUW&RPPDQG^)5575`5HPRWH
The Request ROM Test Report command allows the host to obtain detailed results of ROM
testing during the Continuous Integrity Test or automatic self-testing.
The host receives a response from this command when the Continuous Integrity Test is in
progress only if the Continuous Integrity Test was activated by the host rather than locally by the
user.
The TCS responds to the Request ROM Test Report command by sending to the host the ROM
Test results obtained since the Continuous Integrity Test started or since the TCS was last
powered-up or reset.
'()$8/7
The test results are always reinitialized to zero at the start of the Continuous Integrity Test, when
power is applied, or when the TCS is reset.
23(5$72586$*(
None. (This is a remote command only.)
+26786$*(
<ESC>[>6n
The TCS responds with:
<ESC>[>6;<Ploops>;<Pfail>;<Psum>n
<Ploops> indicates the number of ROM Tests completed since the Continuous Integrity
Test started or since the TCS was last powered-up or reset.
<Pfail> indicates the number of ROM Tests that detected a failure since the Continuous
Integrity Test started or since the TCS was last powered-up or reset.
<Psum> is the decimal equivalent of the last failed checksum. The value of <Psum> is 0
if no checksum errors have been detected.
NOTE
The report may differ from the above format if the Reporting Formal command has been issued. Refer to
the Reporting Formal command description in Chapter 4 for details.
(;$03/(6
<ESC>[>6n
This control string from the host requests a ROM Test report. If only a power-up test has
been performed and no ROM checksum errors were detected, the TCS responds with:
<ESC>[>6;1;0;0n
If the Continuous Integrity Test has completed 12 loops and detected ROM checksum errors
during 5 of those test loops and the most recent cell in error was 165, the TCS responds with:
<ESC>[>6;12;5;165n