Dynapro Technologies Dynapro ET TCS, Application Developer'S Manual

Page: 227 / 337

6-37
•
If the region does not contain any double-width or double-size lines, the region is assumed to
be composed of all normal lines.
23(5$72586$*(
None. (This is a remote command only.)
+26786$*(
<ESC>[7;<P1>;<Pc>;<Pv>t
<P1> is a numeric parameter from 0 through 24 that designates the height of the region in
lines.
If <Pl> is 0, omitted, or greater than 24, a region with a height of 24 lines is defined.
<Pc> is a numeric parameter from 0 through 80, that designates the width of the region in
columns.
If <Pc> is 0, omitted, or greater than 80, a region 80 columns wide is defined.
<Pv> is a selective parameter, designating which portion of the region is affected by the
command.
If <Pv> is 0 or omitted, the attributes of all characters in the region are modified.
If <Pv> is 1, the attributes of only inner characters are modified.
If <Pv> is 2, the attributes of only border characters are modified.
If <Pv> is 3, the attributes of all characters in the region are modified.
3266,%/((55256
Undesirable results may be produced if the Modify Character Attributes in a Region command is
executed on a region that contains mixed line types.
If the region specified runs off the edge or bottom of the screen, the edge of the region is
assumed to be along the screen edges. When Origin Mode is set, the edges of the scrolling region
are handled as if they were the edges of the screen.
(;$03/(6
<ESC>[7t
Modifies the entire screen (if Origin Mode is reset and the cursor is in the home position).
<ESC>[7;12;51;2t
Modifies the border attributes of a region 12 lines high by 51 columns wide relative to the
cursor (which marks the upper left corner of the border).