Dynapro Technologies Dynapro ET TCS, Application Developer'S Manual

Page: 203 / 337

6-13
23(5$72586$*(
None. (This is a remote command only.)
+26786$*(
<ESC>[3;<Pk>;<Pv>u
<Pk> is a numeric parameter that specifies the touchkey whose visual extent is to be
assigned.
If <Pk> is 0 or omitted, the visual extents of all touchkeys are set as specified in this
command.
<Pv> is a selective parameter that indicates the visual extent to be assigned to the touchkey.
If <Pv> is 0 or omitted, no characters in the touchkey respond visually.
If <Pv> is 1, only the inner characters respond visually.
If <Pv> is 2, only the border characters respond visually.
If <Pv> is 3, all characters in the touchkey respond visually.
3266,%/((55256
The host should not explicitly change any attributes of characters within press, auto-repeat, or
toggle touchkeys having automatic visual response by the TCS. If the host changes any of these
attributes, the automatic visual response is affected.
If the visual extent for a press or auto-repeat touchkey is changed after the touchkey is pressed,
but before it is released, the visual extent in effect when the touchkey was pressed is used when
the touchkey is released. Subsequent touchkey presses will use the new visual extent.
If the visual extent for a toggle touchkey is changed while the touchkey is on, the next press will
use the new visual extent, turning the toggle touchkey off. Unwanted visual effects can occur if
the visual extent for a toggle touchkey is changed while the touchkey is on.
Undesirable visual effects may result if this command is used for a touchkey that contains a
mixture of line types.
(;$03/(6
<ESC>[3u
Sets all touchkey’s visual extent to none.
<ESC>[3;0;2u
Sets all touchkey’s visual extent to border.
<ESC>[3;45;1u
Sets the visual extent of Touchkey 45 to inner.