Dynapro Technologies Dynapro ET TCS, Application Developer'S Manual

Page: 236 / 337

6-46
If <Pc> is 0, omitted, or greater than 80, a region 80 columns wide is defined.
<Pv> is a selective parameter that specifies the visual extent of the region to be filled.
If <Pv> is 0 or omitted, all of the region is filled.
If <Pv> is 1, only the inner portion of the region is filled.
If <Pv> is 2, only the border of the region is filled.
If <Pv> is 3, all of the region is filled.
<Pch> is a numeric parameter that specifies the decimal value of the character to be used for
filling the area specified.
If <Pch> is omitted, the default value 251 from within the Extended Character Set is
used (the gray block character when the Static Special Character Font is mapped into the
Extended Character Set).
If <Pch> is greater than 255, 255 is used.
3266,%/((55256
If the region specified runs off the edge or bottom of the screen, the edge of the region is
assumed to be along the screen edges. When Origin Mode is set, the edges of the scrolling region
are handled as if they were the edges of the screen.
Undesirable results may be produced if the Fill a Region With a Character command is executed
on a region that contains mixed line types.
(;$03/(6
<ESC>[2x
Fills the entire screen with the gray block character (value 251 when the Static Special
Character Font is mapped into the Extended Character Set).
<ESC> [2;2;45;3;43x
Fills every character position of a 2 line by 45 column region (whose upper left corner is at
the current cursor position) with a plus (+) character (value 43 when the Static ASCII
Character Font is mapped into the Standard Character Set).
NOTE
These examples assume that the Static ASCII Character Font and Static Special Character Font are
mapped into the Standard and Extended Character Sets, respectively. If this is not the case, the character
that fills the region may differ from the above examples (it may be a custom character).