DynaGen GSC400 Series, Installation And User Manual

Page: 44 / 105

44 of 105
Table 8 – Advanced Menu Layout Summary
Menu Layout Description
J1939 Setup
The J1939 setup contains general
settings for J1939 such as shutdown on
loss of messages. To read parameters
from the J1939 bus please see “Analog
Inputs” below.
High Engine Temp
Oil Pressure
Fuel Level
Oil Level
Fuel In Basin
Low Engine Tmp
Analog Inputs :
These control all aspects of the specific
analog input listed in the left column
such as whether it is a switch, sender, or
obtained from J1939. You can also set
the input you want it to connect to. The
warnings and failures as well as open
and shorted sender detection shutdowns
are also configurable.
Speed Sensing
The speed sensing source (magnetic
pickup, generator voltage, J1939), under
and over speed warnings and failures.
AC Frequency The crank disconnect frequency and the
over/under frequency warning/failures.
AC Voltage
The AC voltage sensing/display is
contained here as well as the over and
under voltage warnings and failures.
AC Current
The CT ratio, AC current sensing and
display enable are contained in this
menu.
Engine Logic All the basic start and shutdown logic are
contained in this menu.
Outputs Setup
This menu allows you to assign a
feature/action to one of eight digital
outputs. For example you can turn on a
digital output when an under-speed
failure occurs.
Exerciser Set
Generators require periodic operation as
part of their scheduled maintenance.
This menu allows settings to control how
often the engine/generator is started and
for how long.
Inputs Setup
This menu allows you to assign
features/warnings, for example low oil
pressure, to one of eight digital inputs.
Advanced Menu
(Password
Protected)
Battery Setup
This menu controls the settings for the
battery under and over voltage warnings
and failures. It also allows the user to set
at what battery voltage to start the