43 of 105
6
Advanced Setup
The GSC400 incorporates an Advanced Setup menu. The possible advanced menu
selections are covered in this section. Only OEMs or advanced and knowledgeable users
should change these parameters.
Before entering the Advanced menu a
password is required to be entered. The
password will consist of a four digit number.
Each number needs to be selected using the
up or down arrows on the GSC400.
Simply choose the correct password number
for each selected position by scrolling to the
proper number followed by the Enter key.
The default password is 0 0 0 0. The
password may be changed anytime. See
Password Setup section.
The Advanced Setup menu on the GSC400
is shown to the right.
Important!
For Firmware Versions Below 2.00
After changing any settings on the controller, the controller needs to be reset. This
can be done one of two ways:
1.
Power off, wait for 2s, and power on the controller.
2.
Press the Run key, wait until the controller begins the start sequence and then
press the OFF key. You will see a flickering of the screen as the controller
updates.
Summary of Contents for GSC400 Series
Page 15: ...Figure 4 General GSC400 System Wiring Diagram ...
Page 16: ...Figure 5 Digital IO Example ...
Page 105: ...105 of 105 ...
