Setting the feed-dog
Service manual H867 Version 00.0 - 08/2013
39
9.2.3 Setting the stroke movement
Sequence
First check the following settings:
•
9.2.2 Setting the feed-dog height in the
Correct setting
At the front dead center (handwheel position 90°) and at the rear dead
center (handwheel position 270°) for the feed-dog, the upper edge of the
feed-dog is at the same height as the upper edge of the throat plates. At
90°, the feed-dog is in the upward movement; at 270°, in the downward
movement.
Cover
• Tilt the upper section backwards
4.4.1 Access to the machine bottom section
Figure 30: Setting the feed-dog stroke
Setting steps
1. Loosen the stroke eccentric setscrews (1).
2. Put the handwheel into the 90° position.
3. Turn the stroke eccentric (2) such that the upper edge of the feed-dog
is in the upward movement and at the same height as the upper edge
of the throat plates.
4. Tighten the stroke eccentric setscrews (1).
Risk of crushing
Switch the sewing machine off before you check and set the
stroke movement of the feed-dog.
WARNING
1
2
(1) - Stroke eccentric setscrews
(2) - Stroke eccentric
Summary of Contents for M-TYPE H867
Page 1: ...H867 Service manual...
Page 91: ......
