Setting the feed-dog
38
Service manual H867 Version 00.0 - 08/2013
5. Turn the pusher eccentric (2) such that the feed-dog and needle no
longer move when the stitch adjustment lever (3) is pressed.
6. Tighten the pusher eccentric setscrews (1).
9.2.2 Setting the feed-dog height in the top dead center
The feed-dog reaches the maximum stroke height at the top dead center
when the position of the handwheel is 190°.
Correct setting
Handwheel in the 190° position:
The upper edge of the feed-dog protrudes 0.8 mm above the throat
plate.
Cover
• Tilt the upper section backwards
4.4.1 Access to the machine bottom section
Figure 29: Setting the feed-dog height
Setting steps
1. Put the handwheel into the 190° position.
2. Loosen the setscrews (2) on the lever (1) at the left, above the hook.
3. Turn the lever (1) such that the upper edge of the feed-dog protrudes
0.8 mm above the throat plate.
4. Tighten the setscrews (2).
Risk of crushing
Switch off the sewing machine before checking and setting the
feed-dog height.
WARNING
1
2
(1) - Lever
(2) - Setscrews
Summary of Contents for M-TYPE H867
Page 1: ...H867 Service manual...
Page 91: ......
