Dürkopp Adler M-TYPE H867, Service Manual

Page: 20 / 92

Setting the handwheel scale
18 Service manual H867 Version 00.0 - 08/2013
5 Setting the handwheel scale
Checking the correct setting
Lock the machine in place in the handwheel zero position (  page 16):

The handwheel is at position 0°.
If a different degree number is next to the pointer (2) in the handwheel
zero position (

page 16), then you will have to reset the graduated
scale. Otherwise you will not be able to work with the handwheel positions
you need for specific settings.
Figure 12: Setting the handwheel scale
Setting steps
The handwheel is fastened using two screws, which you can see through
the screw opening (1).
1. Turn the handwheel such that one screw is under the opening (1).
2. Loosen the screw using a 3 mm hex key through the opening (1).
3. Turn the handwheel such that the second screw is under the opening (1).
4. Loosen the screw using a 3 mm hex key through the opening (1).
5. Lock the machine in place in the handwheel zero position (  page 16).
6. Turn the handwheel scale such that the 0° marking is exactly in the
center of the pointer (2).
7. Firmly tighten the screw using a 3 mm hex key through the opening (1).
8. Remove the locking mechanism (  page 17) .
9. Put the handwheel into the 50° position.
10.Firmly tighten the second screw using a 3 mm hex key through the
opening (1).
Risk of injury
Switch the sewing machine off before you check and set the
position of the handwheel on the arm shaft.
WARNING
2
1
(1) - Screw opening (2) - Pointer