Winder
68
Service manual H867 Version 00.0 - 08/2013
Figure 54: Setting the winder spacing
Setting the winder spacing
10.Turn the winder spindle (12) such that the tear-off knife (11) is at the top
right and is facing the right-hand screw hole (13).
11.Loosen the setscrew in the engaging clamp (5).
12.Set the winder flap (3) such that the upper arm is above the marking for
the XXXL hook (15).
The distance between the winder flap and the outer thread on the
bobbin is then 2 – 3 mm.
13.Set the engaging clamp (5) such that it is resting against the locking
disc (14).
14.Set the engaging clamp (5) such that its distance to the winder wheel (6)
is 0.5 mm.
15.Tighten the setscrew in the engaging clamp (5).
Figure 55: Installing the winder
6
^
<
+
5
,
3
(3) - Winder flap
(5) - Engaging clamp
(6) - Winder wheel
(11) - Tear-off knife
(12) - Winder spindle
(13) - Right-hand screw hole
(14) - Locking disc
1
.
(1) - Winder screws
(15) - Marking for XXXL hook
Summary of Contents for M-TYPE H867
Page 1: ...H867 Service manual...
Page 91: ......
